Notices
Tech Talk Anything technically related to your vehicle should be posted here. If you're looking to have work done, try one of the Regional Forums.

starting problems

Thread Tools
 
Old Jul 11, 2010 | 01:10 PM
  #1  
oneslorsx's Avatar
Thread Starter
Registered Member
 
Joined: May 2010
Posts: 150
Likes: 0
From: Richmond
oneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to behold
Default starting problems

i have a 1993 honda accord that is having starting problems. it turns over and starts but as soon as you release the key, the car cuts off. does anyone know what the problem could be?
Old Jul 11, 2010 | 01:16 PM
  #2  
Z33_Taxi's Avatar
Now drives a SWagon
 
Joined: Jan 2010
Posts: 8,583
Likes: 0
From: Newburgh,NY
Z33_Taxi Z33_Taxi Z33_Taxi Z33_Taxi Z33_Taxi Z33_Taxi Z33_Taxi Z33_Taxi Z33_Taxi Z33_Taxi Z33_Taxi
Default Re: starting problems

There are several possibilities: lack of fuel, spark or compression, these are possible Maintenence items among many other possiblities: spark plugs (worn), ignition wire (Worn), distributor cap (worn), distributor rotor (worn), fuel filter (too dirty), air filter (no air getting in) and timing belt (timing is off)...
Old Jul 11, 2010 | 05:16 PM
  #3  
TheAutoJunction's Avatar
Registered Member
 
Joined: Nov 2009
Posts: 5
Likes: 0
TheAutoJunction has disabled reputation
Default Re: starting problems

If it runs fine till you release the key I would check the ignition switch itself.
Old Jul 12, 2010 | 07:45 PM
  #4  
oneslorsx's Avatar
Thread Starter
Registered Member
 
Joined: May 2010
Posts: 150
Likes: 0
From: Richmond
oneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to beholdoneslorsx is a splendid one to behold
Default Re: starting problems

if you hold the key it was run and drive fine, but as soon as you let go, then it cuts off. And thank you
Old Jul 12, 2010 | 07:48 PM
  #5  
nftuatn's Avatar
baller/dickbutt#69
 
Joined: Nov 2002
Posts: 16,059
Likes: 0
From: hampton
nftuatn nftuatn nftuatn nftuatn nftuatn nftuatn nftuatn nftuatn nftuatn nftuatn nftuatn
Default Re: starting problems

you need a new ignition switch

take the plastic off the column...from underneath there is a few phillip screws and the bottom cover will fall off...then take the top cover off...

you can see the back of the ignition switch and all the wiring...take the small phillips screw out of the white plug and the wireing part of the ignition will be in your hand...

you can start the car and everything from that switch...if looking at the end of it it looks like a slot...take a screwdriver and start the car...and see if it stays running...if it does then you need to either change the wirng part of the key switch itself..
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
RtryPwr
Tech Talk
3
Jan 2, 2007 06:57 AM
chindog69
Tech Talk
5
Dec 23, 2005 07:59 PM
AquaDrake
Tech Talk
3
Dec 20, 2005 06:12 PM
Ej8D16y8-T
Tech Talk
0
Dec 6, 2005 01:02 PM
beanslimm
Tech Talk
2
Oct 28, 2005 12:48 PM




All times are GMT -8. The time now is 12:33 AM.