Head question
Registered Member
Joined: May 2003
Posts: 526
Likes: 0
From: Chesapeake
do it yourself, go to some sites that give you a good idea of how to do it. You can get a dremel and some metal shaving bits and discs and just take out the burrs that's a big part of it. also get a exhaust and intake gasket and port match it. Anyone can do that.
Doin' it
Joined: Nov 2002
Posts: 447
Likes: 0
From: Outta the way
Originally posted by crazychickenhead
when you increase the size of the passages you're going to get more flow, so any machine shop can open up your airways and show you how great it flows on a bench, but that doesnt mean you're going to make more power.
send it somewhere with a guud reputation like portflow if you're insistant on getting headwork done. I hope you've got your bottom end done already, if not, spend your money building your block first.
when you increase the size of the passages you're going to get more flow, so any machine shop can open up your airways and show you how great it flows on a bench, but that doesnt mean you're going to make more power.
send it somewhere with a guud reputation like portflow if you're insistant on getting headwork done. I hope you've got your bottom end done already, if not, spend your money building your block first.
Thread
Thread Starter
Forum
Replies
Last Post
