head problems
r0tard
Joined: Oct 2003
Posts: 1,815
Likes: 0
From: DC Burbs
Re: head problems
I am almost positive its where the oil passes from the block to the head. If i was home i would offer to check it for you. Like i said, i got a head from someone off here an it looked brand new. Didn't check it like a dip and it did what you are describing. Come to find out it was warped ever so slightly.
Did you have this had on the motor before? Or is it new to you (the head i mean?)
I know this sounds petty....but you did make sure it was not upside down?
Did you have this had on the motor before? Or is it new to you (the head i mean?)
I know this sounds petty....but you did make sure it was not upside down?
Last edited by Verbal; Dec 13, 2006 at 07:21 PM.
corona connessuer
Joined: Nov 2002
Posts: 3,425
Likes: 0
From: GUAM
Re: head problems
DESTROYS DONUTS !!
Joined: Nov 2002
Posts: 13,275
Likes: 0
From: the seed has sprouted.
Re: head problems
that was my initial thought....easy to get confused if it was his first head gasket job cause itll slide on either way, but of course the passages dont line up. lets see a picture of the left side of the head nearest the exhaust and itll be apparant if it is or not.
Last edited by MORE IMPATIENT; Dec 15, 2006 at 05:43 AM.
Registered Member
Joined: May 2003
Posts: 526
Likes: 0
From: Chesapeake
Thread Starter
Registered Member
Joined: Dec 2006
Posts: 20
Likes: 0
From: newport news
Re: head problems
well i finally got the head off and found that the head gaket was on properly and still being held in by the dowel pins so I am sending the head to themachine shop and see what they say. The head was on the motor when i bought it and the guy told me it only had a spun bearing on the #3 cylinder. i started it up ever so briefly and it ran then so idunno. thanks though for the opinions I reaally appreciate it and have a general idea of whats going on now
Thread
Thread Starter
Forum
Replies
Last Post
jdmontheway
Want to Buy / Trade ARCHIVE
2
Apr 12, 2008 04:44 PM
