Name: Anthony
Car: 93 honda civic

So finally I finished my car today and got the motor back in. Well I went to pull out my garage car went Into gear fine and clutch felt normal.
Well got about 10ft out the garage and I stopped to check everything over well when I got back in put it in gear and let out the clutch and nothing didnt move at all.

So I pushed the clutch back in well this time it just dropped to the floor. So I got out to check everything and my clutch fork stayed ingaged. So I figure it came off the throw out bearing.

My question is before I pull my motor back out tomorrow will the shift fork coming off the throw out bearing keep it from moving? Just wanna make sure thats my problem

 

the only tranny problems i have are never having enough trannies.

 

Now, think about what you just asked...

think about the workings of a clutch, now tell me the answer to your question.

 

Im definitely going to have to remember to + rep these tomorrow hahaha

 

Figired out the problem. Pressure plate was bad . i dont know why I thought the clutch fork and throw out bearing would be my problem lol

 

Glad you figured it out. Now do you see why I asked you that? Lol