Ok i am going to be boosting my d series soon and was wondering if anyone has any tips on taping my oil pan?

 

Get a professional to do it. Unless you wanna rebuild your motor like me.

 

I bought a universal hose fitting set it up to the oil pan and marked it with a colored pencil. Then I drilled it out, and made sure i got every single last piece of metal out.

the easiest way though...is to have a exhaust shop torch the hole out...then weld the piece you need back in, just make sure NOT to buy a brass fitting.

 

PM thermal (Arnel) and he will do it real quick-like. Im not sure what he charges, but it will be done right.

 

dude I bought the fitting drilled a hole a little smaller than it and then threaded it in there and jb welded it and it never leaked

 

Ok now any advice on the position?

 

yea, about 1/2 way up the side facing towards the front of the car...in the center.

 

take it off the motor buy a stepp down drill bit and use jb weld

 

i wouldnt use jb weld.

 

JB Weld has no place on a car, especially on an engine. Ghetto, ghetto, ghetto.