Wow... I'm assuming this is supposed to be funny. Hahahahaha. I guess.

 

lord....i seriously hope this is a joke

 

Im going to go ahead and suggest you throw everything away and start from scratch.....minus the dremel tool. Throw that away while your at it so you are not tempted to let your stupidity florish once again.

But if you must...post up a video of the first start up. It should be a interesting.

 

Hopefully you don't reproduce...

 

Its not a joke guys. I know it sounds stupid doing internal work with a dremal, but it really can be done!

I just finished installing the new pistons, they look awseome. Their is a little gap between the cylinder wall and piston on cylinder number 7. but it really shouldnt make that much of a difference. Yeah ill video tape the start up.

 

omfg! reading that gives me a headache

 

It makes a difference. Good luck with that.

 

LOL! This is going to be funny.

 

I tell you what, Just hand me a bunch of money, and I'll hand you a bunch of chunks of metal, voila, same result.

Kidding aside, how much work have you done on engines? If you want to grenade that motor and your new pistons, then by all means, start it. You can NOT dremel the inside of that motor. Motors are built on tolerances in the thousandths and more. (thats .001") Theres no way in hell you're going to be able to free hand that tolerance, especially with a dremel.

I hope this is really a joke, but if it isn't, you need to realize were all busting on you because you're going about this completely wrong.

 

ross i cant believe that you've finally finished this. when is your schedueled dyno daate?