crank spins but not the balencer
#1
Registered Member
Thread Starter
Join Date: Jan 2004
Posts: 674
Likes: 0
Received 0 Likes
on
0 Posts
crank spins but not the balencer
94 honda acoord 2.2 16 valve you can see the crank bolt spin but non of the accery drives timing belt spins and motor runs stron is this an easy fix
#5
Lost Cat Magnet
Join Date: Jun 2003
Location: raleigh, nc
Posts: 758
Likes: 0
Received 0 Likes
on
0 Posts
Re: crank spins but not the balencer
broken key or a broken crank. if the woodruf key just sheared off, thats an easy fix.
bbuuttt, more than likely the pulley was loose and it walked back and forth over time, wearing a chunk out of the crank. if that is the case you will have to pull the motor and fix the crank or replace the crank depending on the damage. pull the pulley and inspect.
did you recently have a timing belt or any work done to that side of the engine?
bbuuttt, more than likely the pulley was loose and it walked back and forth over time, wearing a chunk out of the crank. if that is the case you will have to pull the motor and fix the crank or replace the crank depending on the damage. pull the pulley and inspect.
did you recently have a timing belt or any work done to that side of the engine?
#7
MLB! Lets GO!
Join Date: Jan 2004
Location: 59Fifty
Posts: 5,777
Likes: 0
Received 0 Likes
on
0 Posts
Re: crank spins but not the balencer
u know, i hope nothing major is wrong with your engine, but fuck, is too hard to type with a little puncuation? i mean really. im not asking for everything to be perfect and whatnot, but like, not a single puncuation mark was used during the whole statement. im not a spelling nazi or anything, but at least try.
Thread
Thread Starter
Forum
Replies
Last Post
TypeSTurbo
Engine / Exhaust / Drivetrain
1
02-03-2009 07:11 AM