just put new tranny in it and new seals went to test drive it and fluid was all ove the hood and intake then the trans was slipin due to the lack of fluid any ideas or clues ?

thanks for the help

 

check the breather tube, sometimes the junk yards will plug it to keep water out. i would defn check the seals again too.

 

thanks i take a look at that .

 

yea u might wana check the seals again, cause sometimes when u take the old ones off, some of the pieces stay attached and dont realize it, so when u put the new one on, it does quite match up rite.....jus a possiblity....i've seen it happen when changing an oil filter, they take it off and dont realize it, then the oil slides rite out..........but its jus a thing that went through my mind, but hope u figure out wat went wrong and get it fixed...

 

well ive figured it out my trans cooler line clamp broke and was leakin from it
thanks for all yalls ideas i apprecate them ...