vtec conversion
#3
Registered Member
Join Date: Jan 2007
Location: Warrenton
Posts: 561
Likes: 0
Received 0 Likes
on
0 Posts
Re: vtec conversion
I didn't use any parts when I converted them in the past, all you have to do is move a jumper or 2 its been a while since I did it but Ill try to look up the website I used.
#4
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: vtec conversion
You're confused. You're talking about converting an automatic tranny ECU to a manual tranny ECU. P06s are the same ECU as a P28, but they don't physically have the VTEC parts on the circuit board. Add the parts, and you have a P28. Don't add the parts, and you don't have VTEC. It's very simple. You can't add VTEC by moving jumpers around because you don't have any solenoid drivers..
Last edited by Fabrik8; 07-27-2008 at 04:51 PM.
#5
Registered Member
Join Date: Jan 2007
Location: Warrenton
Posts: 561
Likes: 0
Received 0 Likes
on
0 Posts
Re: vtec conversion
You're confused. You're talking about converting an automatic tranny ECU to a manual tranny ECU. P06s are the same ECU as a P28, but they don't physically have the VTEC parts on the circuit board. Add the parts, and you have a P28. Don't add the parts, and you don't have VTEC. It's very simple. You can't add VTEC by moving jumpers around because you don't have any solenoid drivers..
#6
Re: vtec conversion
what is the code inside the ecu it should be either 11f0 or 1728 and its printed inside the ecu on the curcuit board right on the top -center of the board and i charge $75.00
with a tune of your choice.
with a tune of your choice.
Thread
Thread Starter
Forum
Replies
Last Post