CivicRenModelX

Close Thread Please!!

zappas

are you asking how to do it, or are you asking for someone to do it for you?


and which studs ? front or rear.

TurboEG8

if it is the front i hope....... and i'm pissine in the wind on this one, that its not the hub-over design
it is though need a slide hammer a lot of elbow grease and about two hours time if you haven't done it before just to get the old stud out good luck
you better go to the auto parts sore and cop a haynes book

murphy660

b.s. big hammer get it out

put washers on it and the lugnut on it'll come threw

TurboEG8

wrong murphy but good try
the front of this accord mentioned has a hub over design that means the brake rotor is behind the hub which means the hub has to be removed to access A: the wheel studs and B: the brake rotor

CivicRenModelX

The studs are on the front of the car. I really need someone to come help me fix it. I tried yesterday for hours and can't figure it out.