ok we just swaped an obd1 b18c into a 99 civic ex

now

1. where can i get the front driver side torque mount that will fit on my car and engine?

2. im shooting codes 9, 21, and 41.

9 i beleive is the dizzy.

21 i believe is the vtec sol. if we plug in vtec then it makes a popping sound.

41 i believe is the O2 sensor

what should i do about these?

the srs light is staying on, what would cause this?

when we shut the car off the same lights you get when you put the car on acc stay lit. but they are very dim.

we are using the d16 alternator for the moment because the plugs were different, and i have a 99 GSR alt. coming in tom.

please help

thank you

 

Well on mine i used the integra torque mount but put the civic end on it and it worked for me

 

bump

 

the codes your throwing...

9: CYP - cylinder sensor
21: VTEC spool solenoid valve
41: Primary oxygen sensor heater

i would check your wiring.. when i did my swap i threw the some of the same codes because of a broken clip and lose wires

the SRS light is coming on because your airbags are not hooked up, again probably just a wiring issue.

i would say just take it to a local shop, they can probably have you in and out in under an hour.

 

its at a shop as we speak, thanks

 

did you get the obdII to obdI conversion harness?