i just got my cylinder head its a b18c and i got a b16a engine.i was going to install it by myself but its a lot of work and i dont even know if its fit on my engine and what else do i need to install it?

 

seen it done before but never done it myself will raise the comp. a little bit. just bolt it on and torque it down like a regular head should be good to go.

 

^^

Correct. I believe you may need the B18c headstuds though..

 

wont the gsr head lower compression? since its uhh... open chamber, as where the b16/b18c5 head is like a closed style.

could be wrong, but im pretty sure im not

oh yeah all b series heads fit all b series engines, just use the gasket that matches the block not the head. better yet use a cometic gasket.