help any1
#1
help any1
i just got my cylinder head its a b18c and i got a b16a engine.i was going to install it by myself but its a lot of work and i dont even know if its fit on my engine and what else do i need to install it?
#2
Registered Member
Join Date: May 2003
Location: Chesapeake
Posts: 526
Likes: 0
Received 0 Likes
on
0 Posts
Re: help any1
seen it done before but never done it myself will raise the comp. a little bit. just bolt it on and torque it down like a regular head should be good to go.
#4
fabricated reality
Join Date: May 2003
Location: Va Beach
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
Re: help any1
wont the gsr head lower compression? since its uhh... open chamber, as where the b16/b18c5 head is like a closed style.
could be wrong, but im pretty sure im not
oh yeah all b series heads fit all b series engines, just use the gasket that matches the block not the head. better yet use a cometic gasket.
could be wrong, but im pretty sure im not
oh yeah all b series heads fit all b series engines, just use the gasket that matches the block not the head. better yet use a cometic gasket.
Thread
Thread Starter
Forum
Replies
Last Post