Just like the tidle says, I want to put on in my car.

I want to install the arm and the box (top and bootom) with the OEM K/N filter in the box. Then i might fab some sort of tubing that would run down into the fender well kinda like and Ice box of sorts.

Does anyone know if the box will bolt into the EG engine bay?

 

Yeah it should. There really isn't too much difference from your stock air box and that one though. Just a little bigger. Get an actual intake youd be better off.

 

The stocker could pull some peak numbers over after-market, but after-market seem to be the most efficient all-around.

If you plan on being in high rpm's (power-band) then a short intake or ram-air would work, if you like a "meatier" power-band get the cold-air (longer piping).



Read the articles on Team-Integra.net

 

Im not looking to improve performance fellas, i just wanted to know if it will fit in the bay.

thanks for the comments anyways.

 

If you want to see if it fits, go out there and try. This is an enthusiast's site.. not to come down on you, but this is kind of a worthless thread.

 

I mean it isn't that bad of a question to ask. But yeah it should fit.