can any one help?
#1
Registered User
Thread Starter
Join Date: Sep 2003
Location: va beach
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
can any one help?
hey just wondering if any of yall who live in the beach might be able to help me with 2 things on my bike. the back brakes were bleed 3 months ago cause they werent working right. now they dont work again. and also the brake lights dont work. any body with the knowledge and willing to help let me know.
#2
Registered Member
Join Date: Sep 2003
Location: fredericksburg
Posts: 437
Likes: 0
Received 0 Likes
on
0 Posts
Re: can any one help?
you have a leak somewhere in the rear brakes since air is getting in somehow. I could make sure all the lines are tight that go to the master cylinder, the caliper, and the bleeder screw on the caliper. you could also has a fail in the master cylinder. or a pin hole in the line. Also, take the reservoir cap off and make sure that rubber boot thing is fitting right or is even the correct boot for your bike. If none, of that works, I don't know what your problem is.
#3
Registered User
Thread Starter
Join Date: Sep 2003
Location: va beach
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Re: can any one help?
thanks man i tried bleeding them and fluid came out. havent tried the other things yet but i will have to try. the lights should come on with the front or the rear brakes right?
#4
Registered Member
Join Date: Sep 2003
Location: fredericksburg
Posts: 437
Likes: 0
Received 0 Likes
on
0 Posts
Re: can any one help?
ya the brake lights come on when you hit either brake. say when you hit the front brake, the brake lights work, but when you hit the rear brake, they don't work. then you most likely have a loose connection or no connection with the little sensor at the pedal(or in front brake case the the sensor on the brake lever perch). If nothing at all, you may have blown both brake lights but not running tail light. Have you wired anything up recently for aftermarket stuff?
#5
Registered User
Thread Starter
Join Date: Sep 2003
Location: va beach
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Re: can any one help?
well its my brothers old bike and i have only had it a month. theres a power commander back there and an alarm system which isnt even connected. i tried it but didnt seem to work. i did see two power wires and two ground wires coming from just below the brake lights. not sure but i think that may have somthing to do with it. cause the brake lights dont work whenever you hit either brake but the taillights light fine
#6
Registered Member
Join Date: Sep 2003
Location: fredericksburg
Posts: 437
Likes: 0
Received 0 Likes
on
0 Posts
Re: can any one help?
might pull the bulbs out and make sure the brake light portion of the bulb is good. if not, maybe a fuse. also trace the two wires and see where they go. its not a hard fix.