will tha jdm b20 work with my mounts?
09-10-2005, 09:26 AM
#1
Jump In
Thread Starter
Join Date: Nov 2004
Location: Richmond/VCU
Posts: 723
Likes: 0
Received 0 Likes
on
0 Posts
will tha jdm b20 work with my mounts?
I have a 89 lude 2.0 si (B20A5) and its startin to wear out.....I want a jdm b20 but I don't know if my stock mounts will work....I think they should since my car is a 2.0 and the new engine is a 2.0....just let me know...thanks.
ALSO!!!!! The swap says that it does not come with the tps sensor and altnator...could I use my old ones...and would I need any tranny parts?
it's on hmotorsonline.com....like the fourth page.
ALSO!!!!! The swap says that it does not come with the tps sensor and altnator...could I use my old ones...and would I need any tranny parts?
it's on hmotorsonline.com....like the fourth page.
Last edited by integra-t; 09-12-2005 at 12:34 PM.
09-11-2005, 07:58 PM
#2
89silude
Join Date: Oct 2003
Location: Roanoke, VA
Posts: 1,765
Likes: 0
Received 0 Likes
on
0 Posts
Re: will tha jdm b20 work with my mounts?
yes, just fine. the b20a is the same motor that you have. just a bit higher compression.
it'll also work on the USMD b21a1 mounts that are found in the 90-91 si preludes.
it'll also work on the USMD b21a1 mounts that are found in the 90-91 si preludes.
Thread
Thread Starter
Forum
Replies
Last Post