I remember seeing this on here somewhere, for the past 20 minutes i've searched and came up with nothing. How do you wire it up?

 

Its simple.

1) Get a light

2) Send the power wire to the vtec solenoid

3) Send a ground wire to a ground point


When vtec engages... light turns on.

 

Hmm. Thanks nick! Also, did you get my PM?

 

I made one of these that I use to troubleshoot people's motors when they have vtec problems. It's quite simple. Are you making one just to show?

 

No, Im making it for "troubleshooting" cause Sometimes I can't tell if my car is hitting VTEC or not. It's gay.

 

That's cool. Just don't cut into the harness when using it. I made a small "Y" type connector that pigtails into the harness and solenoid. Then I just plug the 8 foot test light wire into the lead that comes off the "Y" harness...then run the wire through the hood seal and through the passenger's window. Works great!

If you continue to have problems from there you'll need to get a direct reading oil press gauge to ensure correct oil pressure.

 

Ah ha. My friend thought he was slick and was going to drive my car with the speedo un-hooked so my vtec wasn't engaging. and thanks Yell88crxsi