anyone wanna help me change my slave cyl and bleed the clutch? never done it before. im about 90% pos. thats whats dead on the clutch.

 

It shouldn't be that hard. It only took me about 45 minutes to replace and bleed mine all by myself.

 

excellent. i was told its basically just unbolt it from the tranny and swap it. thats the easy part i guess. ive just never bled any breaks/clutch or anything. dont wanna spew shit everywhere =]

 

You shouldn't spew too much out. There should be a bleeder valve you have to loosen and tighten to bleed it. Put the pedal to the floor, tighten the valve, then pull the pedal up. Open the valve and push the pedal down again. Keep doing that until it's shooting out fluid the whole time you press it down.

*NOTE* This is all for a Mazda hydraulic clutch system. It was 45 min for me to change a clutch master cyl too, the slave should only be like 15-30.

 

its un bolt and put the new one on. ya you will have to bleed but that simple.

 

You get it fixed yet Crate?

 

hahah, it was easy as shit. =]

i got it off, and slapped the one one back on. just gotta bleed it in the morning.