Notices
Tech Talk Anything technically related to your vehicle should be posted here. If you're looking to have work done, try one of the Regional Forums.

Oil pressure problem

Thread Tools
 
Old May 28, 2004 | 11:22 AM
  #1  
VT Prix GT 2006's Avatar
Thread Starter
Motor Trend Mechanic
 
Joined: Sep 2003
Posts: 250
Likes: 0
From: Blacksburg/New Kent, VA
VT Prix GT 2006 is an unknown quantity at this point
Default Oil pressure problem

I've had this problem for quite sometime. I currently get around 0 psi at idle which sets off the dummy light. Unfortunately I do not have an oil pressure gauge but I can tell that my oil pressure is low across the board because while crusing, engine coolant temps reach anywhere from 195-200*. This is not normal since I have a 180* drilled thermastat along with an aftermarket PCM which turns on the cooling fans once the temperature exceeds somewhere around 185. This problem is very annoying and now at idle I can hear something ticking, I'm assuming its my lifters since they aren't getting any oil pressure. I'm going to install a new oil relief spring today that I ordered earlier this week and I'm praying that this will be a permanent fix for this problem. Although in the back of my head I have this fear that its my bearings, although they were replaced in September of 2003 when I broke three of them. Any thoughts?
Old May 28, 2004 | 11:31 AM
  #2  
Bert's Avatar
hybrid no more :(
 
Joined: Apr 2003
Posts: 241
Likes: 0
From: Virginia Beach
Bert Bert Bert Bert Bert Bert Bert Bert Bert Bert Bert
Default Re: Oil pressure problem

stop driving the car... get a oil pressure gauge for piece of mind....it took only a split second for my bearing to look like this



my other bearings were scored but this one was the worst... luckily i was able to save my motor... all this took was one incident of oil starvation. i now have a oil pressure gauge and it has already saved me again.
Old May 28, 2004 | 06:46 PM
  #3  
VT Prix GT 2006's Avatar
Thread Starter
Motor Trend Mechanic
 
Joined: Sep 2003
Posts: 250
Likes: 0
From: Blacksburg/New Kent, VA
VT Prix GT 2006 is an unknown quantity at this point
Default Re: Oil pressure problem

Yeah I'm hoping it won't have to come to that. I've already had that issue before and replaced all the bearings, so I don't know why it'd happen again in such a short amount of time. Oh well, I'll run some scans and monitor the oil pressure and if it doesn't work, then I guess I gotta tear the engine apart and take a look at the bearings...

Thanks for the input.
Old May 28, 2004 | 08:02 PM
  #4  
sk8rmike's Avatar
Bitches get Stitches
 
Joined: Mar 2003
Posts: 3,959
Likes: 0
From: Chesapeake
sk8rmike sk8rmike sk8rmike sk8rmike sk8rmike sk8rmike sk8rmike sk8rmike sk8rmike sk8rmike sk8rmike
Default Re: Oil pressure problem

0 psi and i'd say you already spun at least one rod....
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
anothercivic
Tech Talk
2
May 20, 2008 04:43 PM
Moriar
Tech Talk
1
Aug 11, 2005 06:51 PM
Crate
Offroad / 4x4
18
Jun 21, 2005 08:09 AM
B-rock
Tech Talk
2
Aug 13, 2003 12:04 PM




All times are GMT -8. The time now is 12:20 PM.