Need quick answer........should be simple, Honda people inside
#1
<----BigBake
Thread Starter
Join Date: Nov 2002
Location: 919
Posts: 4,505
Likes: 0
Received 0 Likes
on
0 Posts
Need quick answer........should be simple, Honda people inside
Gotta go to BFE to change a valve cover gasket, plugs, and wires on a '94 Accord. Not even sure what model it is, but it has a 4 cylinder. Plugs and wires are self-explanatory.....and I can only assume the VCG is as well. I just need to know what tools I'll need.....
Anyone help out?
TIA
Anyone help out?
TIA
#3
#4
Slappin Curtis
Join Date: Aug 2007
Location: Roanoke
Posts: 1,729
Likes: 0
Received 0 Likes
on
0 Posts
#5
<----BigBake
Thread Starter
Join Date: Nov 2002
Location: 919
Posts: 4,505
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need quick answer........should be simple, Honda people inside
Thanks fellas. These VC's have the half-arc cam ridges like most OHC motors? Just need to know if I should bring some RTV for those if so.....
#6
Slappin Curtis
Join Date: Aug 2007
Location: Roanoke
Posts: 1,729
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need quick answer........should be simple, Honda people inside
Yes, It can't hurt, especially depending on the age of said shit box. You shouldn't need any, the valve cover has its own little slot that it sits in all around the valve cover, but a little here and there won't hurt.
#9
Slappin Curtis
Join Date: Aug 2007
Location: Roanoke
Posts: 1,729
Likes: 0
Received 0 Likes
on
0 Posts
#10
Registered Member
Join Date: Jun 2009
Location: Richmond VA
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need quick answer........should be simple, Honda people inside
not to state the obvious but take a screwdriver and rubber hammer to get the VC off. they get stuck often