need help please
#1
Registered User
Thread Starter
Join Date: Nov 2002
Location: gloucester
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
need help please
ok guys heres the deal. i got a 84 s10 getting ready to be painted original color i want to shave the door handles and have good idea of how to do it but i wanna do it right if theres anyone out there that is familiar with how to do and would like to make a few extra bucks one sat just assisting me on how to do i would really appreciate it!!!! i know that sounds pathetic but its better than trying and fucking up cause i was to good to ask for help so let me know fellas
#2
It has 4 Doors...
Join Date: Nov 2002
Location: Fredericksburg,Va
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
to be honest bro the easiest way is to:
remove the door panel
then unscrew/bolt the handle and remove it
then have a plate cut to fill the hole snuggly
then w/ a welder tach it up moving to various spots until its in place..
then finish welding all the way around (have to be careful not to have the welder set to high as it could warp the door)
after the plate is welded you need to grind down the welded area
prep,bondo sand, primer and paint...
I'm not a welder so hope this might help you just a little..
remove the door panel
then unscrew/bolt the handle and remove it
then have a plate cut to fill the hole snuggly
then w/ a welder tach it up moving to various spots until its in place..
then finish welding all the way around (have to be careful not to have the welder set to high as it could warp the door)
after the plate is welded you need to grind down the welded area
prep,bondo sand, primer and paint...
I'm not a welder so hope this might help you just a little..
Last edited by Whtehnda93DXSdn; 09-06-2003 at 06:34 PM.