We are building a 50trim powered gst with greddy electronics (e-manage and e-01 programer/boost controller)

have full rebuild kit from machV, hks 264,272 cams, and we need to put the motor together. the only thing is...never done it before. Is there anyone out there that would be kind enough to come over and give us some help? or maybe a website with a guide?

Thanks alot for any help.

 

were are you located at?

 

get a chiltons manual, its helpful. ive built 4g63t about 4 times now. i would help you but i dont think i live near you + i am busy building my new AWD car good luck

 

sounds like a blast... i am making 427whp with that setup.. only using a SAFC instead of e-manage.. i am thinking of swithcing to e-manage.... it is a very nice unit.. the E01 boost controller on the other hand is a POS and very unstable.. i'd save the money and use a mechanical.. any questions.. ask

 

i've relocated to VA beach. on birdneck. so if anyones close any help or guidance would be great.


..::edit::..
Were using the E01 becuase it can interface with the E-manage. if worst coems to worst a manual one will be used and he e01 for programming

 

if you need help with motor assembly, general tuning etc i can help you out. manual boost controllers suck for high boost apps. give the elect. a shot.