Which machine shop uses torque-plates for boring
#1
RIP Chris Schader
Thread Starter
Which machine shop uses torque-plates for boring
when i get my block machined i am going to want to take it to a machine shop that uses a torque plate when they bore and hone. does anyone know for sure which ones do? its for a 2.0L 4G63T.
#4
Registered Member
Join Date: May 2004
Location: Alexandria, VA
Posts: 2,080
Likes: 0
Received 0 Likes
on
0 Posts
Re: Which machine shop uses torque-plates for boring
why is it that u wanted it to be used with a torque plate?? from my experience with machining it was all done by hand drill
#5
RIP Chris Schader
Thread Starter
Re: Which machine shop uses torque-plates for boring
torque plates allow for the straightest possible bore so in other words i dont want the chance of it being fucked up and have my car smoke alot.
Thread
Thread Starter
Forum
Replies
Last Post
mach442
Automotive Discussion
9
10-01-2008 07:14 AM