Injectors Not Pulsing
#1
Registered Member
Thread Starter
Join Date: Jul 2006
Location: chesapeake
Posts: 1,203
Likes: 0
Received 0 Likes
on
0 Posts
Injectors Not Pulsing
car will start for a sec and cut off its getting fuel pressure and power but its not pulsing so there not squirting so it wont run we just put this ls in this crx and did all the wiring twice and its rite just something is still acting up
please help
please help
#2
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: Injectors Not Pulsing
Ok, so here's my diagnosis.
The injectors work fine, because if they didn't the car wouldn't start.
Chances are, you have a critical sensor fault, most likely something that senses rotating position. The engine is turning over and the ECU is freaking out when it can't figure out where it is after the crank cycle is done.
Any check engine lights, and are you using the correct ECU for that engine?
The injectors work fine, because if they didn't the car wouldn't start.
Chances are, you have a critical sensor fault, most likely something that senses rotating position. The engine is turning over and the ECU is freaking out when it can't figure out where it is after the crank cycle is done.
Any check engine lights, and are you using the correct ECU for that engine?
#5
JAY SPEC
Join Date: Sep 2003
Location: Chesapeake/ODU
Posts: 3,170
Likes: 0
Received 0 Likes
on
0 Posts
Re: Injectors Not Pulsing
Ok, so here's my diagnosis.
The injectors work fine, because if they didn't the car wouldn't start.
Chances are, you have a critical sensor fault, most likely something that senses rotating position. The engine is turning over and the ECU is freaking out when it can't figure out where it is after the crank cycle is done.
Any check engine lights, and are you using the correct ECU for that engine?
The injectors work fine, because if they didn't the car wouldn't start.
Chances are, you have a critical sensor fault, most likely something that senses rotating position. The engine is turning over and the ECU is freaking out when it can't figure out where it is after the crank cycle is done.
Any check engine lights, and are you using the correct ECU for that engine?
#9
Registered Member
Thread Starter
Join Date: Jul 2006
Location: chesapeake
Posts: 1,203
Likes: 0
Received 0 Likes
on
0 Posts
Re: Injectors Not Pulsing
well to late now after hours and hours of trying to get running its toast now the head gasket is leaking got milky oil need new motor please help
#10
Re: Injectors Not Pulsing
Are you sure the crank angel sensor is wired right. if that is reverced it witl do what you are talking about some diagrams are wroung on the pinout location ff-squad is one of them .