Honda Injector resistor box., honda guys?
Thread Starter
Registered Member
Joined: Aug 2003
Posts: 601
Likes: 0
From: Hampton
Honda Injector resistor box., honda guys?
anyone using DSM low impedence injectors, using one of these to run them? do you just tap the resistor box into the lead injector wires that go towards the computer? you dont have to completely cut the wires?
I <3 BOOST
Joined: Jul 2003
Posts: 2,052
Likes: 0
From: Del Rio, TX/Yorktown
Re: Honda Injector resistor box., honda guys?
then you didnt look at a quality setup. mine have been great for almost a year. Its all about doin a good soldering job and a quality shrink wrapping followed by electrical tape and loom. do it right and its awesome!
Go Team Marlboro
Joined: Jul 2003
Posts: 2,419
Likes: 0
From: Roanoke, VA
Re: Honda Injector resistor box., honda guys?
the wires goin to the ecu are usually a ground. the resistor box goes inline with the power wire for the injectors. One wire on each injector all comes back to one source, put the resistor box in there 
Thread
Thread Starter
Forum
Replies
Last Post
stephenb852000
Want to Buy / Trade ARCHIVE
0
Oct 22, 2007 07:07 PM