Determining a bad coil...
#1
Registered Member
Thread Starter
Join Date: Jan 2005
Location: Chesapeake
Posts: 2,098
Likes: 0
Received 0 Likes
on
0 Posts
Determining a bad coil...
I have tested my coils in my car and redid ALL of my grounds and I still get an extremely pathetic spark which happens to spark a few times and just quit after that when I crank the engine.
What the fuck is going on? The resistance is reading at 0.6 ohms which is good considering it should be between 0.2 and 1.0 ohms. What could be making something like this happen? I would just go ahead and replace the coil-igniter assembly, but they run $250 or more, and I highly doubt that it's actually failing.
What the fuck is going on? The resistance is reading at 0.6 ohms which is good considering it should be between 0.2 and 1.0 ohms. What could be making something like this happen? I would just go ahead and replace the coil-igniter assembly, but they run $250 or more, and I highly doubt that it's actually failing.
#3
Registered Member
Thread Starter
Join Date: Jan 2005
Location: Chesapeake
Posts: 2,098
Likes: 0
Received 0 Likes
on
0 Posts
Re: Determining a bad coil...
Fuck. Think I found a problem... About 4 ECU wires (including a ECU ground) were damaged to the point that they were almost nearly severed. I found it under my carpet.
Thread
Thread Starter
Forum
Replies
Last Post
sikcrx89
Parts ARCHIVE
10
02-17-2008 02:30 PM
gsrSII
Parts ARCHIVE
46
01-24-2008 04:39 PM