Alright, I'm swapping out my Z6 manifold for the Y8. Why? Because my Fuel rail and FPR fit on the Y8 and I've heard good things about the Y8 as opposed to the Z6. Well, anyways, I've figured out where to connect all the hoses and sensors except the IAT sensor from the Z6 intake manifold. There isn't a place for it on the Y8 IM. Does anyone know where it is located on Y8 engine or what I would do with that sensor?

 

no idea, hopefully chahonda responds, hes the d series mastaa.....

 

D16Z6 IM

 

D16Y8 IM

*Note: I kept the original IAC valve location since the plug from the D16Z6(2 wire) matched the Y8's. The picture from which this came from was a swap from a Y7 to a Y8, in which the Y7 has a 3 wire sensor. So just ignore the IAC valve if it confuses anyone.

 

drill a hole in that bitch and put your shit in there.......

 

HmmMm, that did cross my mind... Any other suggestions?

 

do all your sensors and shit fit, and does that manifold even fit your car? if youve heard of people doing it then there has to be some information about it somewhere........

 

Yea, all the sensors fit. The IM fits. Me and a friend already figured out how/where all the hoses go. It's just that IAT sensor that ISN'T located on the Y8 IM...

 

you have a d16y8 manifold that is off of an automatic car.
you can drill out the correct holes but if you do be very careful that you get all of the holes lined up. hope that helps.

 

Are you sure it's off a automatic. I got it from Spooledex and I could've sworn his civic was 5 speed. Oh well, Thanks.