D series IM
Thread Starter
Registered Member
Joined: Apr 2003
Posts: 1,053
Likes: 0
From: Va Beach
D series IM
Alright, I'm swapping out my Z6 manifold for the Y8. Why? Because my Fuel rail and FPR fit on the Y8 and I've heard good things about the Y8 as opposed to the Z6. Well, anyways, I've figured out where to connect all the hoses and sensors except the IAT sensor from the Z6 intake manifold. There isn't a place for it on the Y8 IM. Does anyone know where it is located on Y8 engine or what I would do with that sensor?
Thread Starter
Registered Member
Joined: Apr 2003
Posts: 1,053
Likes: 0
From: Va Beach
D16Y8 IM
*Note: I kept the original IAC valve location since the plug from the D16Z6(2 wire) matched the Y8's. The picture from which this came from was a swap from a Y7 to a Y8, in which the Y7 has a 3 wire sensor. So just ignore the IAC valve if it confuses anyone.
*Note: I kept the original IAC valve location since the plug from the D16Z6(2 wire) matched the Y8's. The picture from which this came from was a swap from a Y7 to a Y8, in which the Y7 has a 3 wire sensor. So just ignore the IAC valve if it confuses anyone.
Last edited by Not_Blazin; Dec 1, 2003 at 07:38 AM.
DESTROYS DONUTS !!
Joined: Nov 2002
Posts: 13,275
Likes: 0
From: the seed has sprouted.
do all your sensors and shit fit, and does that manifold even fit your car? if youve heard of people doing it then there has to be some information about it somewhere........
