Car: 91 Honda Accord

Problem: The car will not relese the clutch pedal once its in. you can push it in fine, but it wount push back out. we put fluid in the reservoir and tried it and it worked fine. later on, we bled the system and since then it hasnt been ok. we replaced the slave cylinder because whenever someone would push the clutch in, the other person could see that the poushrod on the slave cylinder was not moving. after installing the new one, we tried bleeding it but its still not fine.wtf? could it be the master cylinder?

 

I had this same problem on my Del Sol. Outside of having a bed bearing in the tranny. We replaced the slave and bled it and got enough pressure to drive it. Then we did the master cylinder and it fixed the problem(now I get why it recomended to do both cylinders at the same time.)

 

make sure you do both master and slave and i would reccemond gettin a good brand not some cheap shit

 

Yes good point LS. I did OEM directly from honda just becuase it had lasted 205,000 miles before. so why wouldnt it cut close to it again