i have a b16 cable trans with cracked bellhousing and a ls cable trans with a good housing bad gears how hard would it be and how i would go about putting the ls bell housing on the b 16 trans any input would help

 

I just went threw this but I paided a shop haha..

 

This link with pics may help. It's for an Integra, but close. You can also Google search for a "B16 Clutch install" which removing the bellhousing is one of the steps.

 

Please request a refund for that GED tuition.

 

How much did it cost at the shop

 

It shouldn't be that hard.. the trans/bellhousing line up.

Just take out all the bolts, and there is a little bitch clip, but once you deal with that the bellhousing should come right off. Don't move anything around inside the trans because you got to line shit up somewhat if I remember correctly. Slide the new bellhousing on and you should be butter. If you want detailed instructions I can help you out.

..

also, Jarrod is selling EF B-series mounts.

https://www.vadriven.com/forums/blackhole-6/place-racing-solid-motor-mounts-171667/

 

i cant get that damn snap clip off any suggestions? thanks

 

do all of the guts stick to the bell housing side or the case side?