i have been reading in my own books and on line but its still not connecting with me and mabie some one can explain it better.
i have a 88 hf crx and a b18a1 that will go in it.
my questions are when i am doing the underside, what is up with the axles.
does any year integra passanger side axle fit to my passanger side.
as for the driver side, i have been told the driver side axle depends on the intermidiate shaft, which is where?,

basically i want to get these and be ready for when i finish this swap and this axle problem is frustrating me.

^^^ this is assuming i have gotten the front knuckles and hubs , calipers, rotors and brake lines from an ex.

appriciate any advice,tips,negative comments. w/e

 

all you need to get are si/dx front hubs from the same year crx, then the ls axles will just slide into place (assuming you have the dust ring removed)

 

so it dosnt matter what year of ls axles i use?, after i have the hubs of an 88 si/dx

 

chok knows what he's talkin about..

 

Use DA LS axles.

 

... if you have a cable transmission then you need 1990 acura integra ls axles non abs. and a 1990 acura integra ls half shaft which goes into the transmission on the drivers side and bolts up to the back side of the block. If you have a hydraulic transmission then the axles and half shaft are different.

 

yeah i have a cable trans. thanks for the info!

 

hope you didnt for get to beat the shit out of the side where the alt. goes......and i used the abs axles with my ef sedan which had the same year hubs for abs