Aftermarket Intake Manifolds
#1
Registered User
Thread Starter
Join Date: Oct 2005
Location: Manassas
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
Aftermarket Intake Manifolds
Just wondering if anyone had installed an aftermarket intake manifold like the STR/ Golden Eagle/ Venom and what was involved with the installation? Do all of the stock sensors bolt back up? Are there any modifications needed? Any re-locating of sensors/vac lines? Does anyone any any pics of manifolds installed?
I have a Venom Drag Manifold and am doing some research before installing. I had to buy a remote IACV relocator but was wondering if anything else was needed? It's for an H22. I also don't understand how to run the coolant lines that come off the brass fitting on the left side of the intake runners as shown on the pic below. Your help would be greatly appreciated.
I have a Venom Drag Manifold and am doing some research before installing. I had to buy a remote IACV relocator but was wondering if anything else was needed? It's for an H22. I also don't understand how to run the coolant lines that come off the brass fitting on the left side of the intake runners as shown on the pic below. Your help would be greatly appreciated.
#2
Re: Aftermarket Intake Manifolds
You will need to bypass the IACV, which is what that little plate is for.
You will need to relocate you IAT, to your intake piping.
Everything else should be the same.
**edit** Your's has no-where to mount a throttle cable...
(just caught it was for an h22, maybe a little different that a b-series)
You will need to relocate you IAT, to your intake piping.
Everything else should be the same.
**edit** Your's has no-where to mount a throttle cable...
(just caught it was for an h22, maybe a little different that a b-series)
Thread
Thread Starter
Forum
Replies
Last Post