97 Accord - Replacing Oil Pressure Switch
#1
97 Accord - Replacing Oil Pressure Switch
Is it possible to replace the oil pressure switch without jacking the car up and going underneath?
The car is a 97 Honda Accord 2.2 non-vtec.
Thanks.
The car is a 97 Honda Accord 2.2 non-vtec.
Thanks.
#4
Re: 97 Accord - Replacing Oil Pressure Switch
OP, do you have the new switch? Do you have a deep socket of the correct size, extension, ratchet? Do you know where it is located? Can you get your hand on it and a flat screwdriver to pry the boot off? Do you have some sort of thread sealant to install the new one. Did you know that the boot will be hard as a brick in these temps and will most likely rip (assuming since you have no jack or stands that it will not be in a heated garage). If you can answer NO to any of these, pay someone else to do it.
#6
Re: 97 Accord - Replacing Oil Pressure Switch
Is this boot not replaceable? I'm assuming its going to be brittle as its been on there for 16 years.
Why would I pay someone to do this? It seems simple enough.
Why would I pay someone to do this? It seems simple enough.
#7
Re: 97 Accord - Replacing Oil Pressure Switch
Also google is your friend, http://www.ehow.com/how_5882215_repl...re-switch.html. <-----this will be the same procedure.
Last edited by 0bd2eg; 01-25-2013 at 03:17 AM.
Thread
Thread Starter
Forum
Replies
Last Post