94 integra heat question
#1
Registered Member
Thread Starter
Join Date: May 2006
Location: GA
Posts: 701
Likes: 0
Received 0 Likes
on
0 Posts
94 integra heat question
94 ls integra with a/c still, worked when it was bought but all of a sudden it stopped working.
There a a "nipple intake" on it and it seems to have melted through one of the a/c lines.
Would that affect the heat or just the a/c?
we bought a heater core for the car but dont want to go thorugh the hassle of doing that if that is not the problem
any reply would be greatly apreceited
There a a "nipple intake" on it and it seems to have melted through one of the a/c lines.
Would that affect the heat or just the a/c?
we bought a heater core for the car but dont want to go thorugh the hassle of doing that if that is not the problem
any reply would be greatly apreceited
#2
Registered Member
Thread Starter
Join Date: May 2006
Location: GA
Posts: 701
Likes: 0
Received 0 Likes
on
0 Posts
Re: 94 integra heat question
nvm found the answer, dose anyone know where the bleeder valve is for the coolant. and how do you tell if the thermostat is locked/ gone bad?
#3
Re: 94 integra heat question
a thermostat will only fail in 2 positions, open or shut. If your car takes FOREVER to warm up,or doesnt reach full opt temp,then its failed in the open position. If your car overheats after started and never reaches operating temp and holds it,its in the closed position. If you want you can test it when you take it out. Boil a pot of water and drop it in and see if it opens.
Thread
Thread Starter
Forum
Replies
Last Post