I have a 2002 wrx and just installed perrin fuel rails. In the re-install process i came across a vacuum line that seems to not have a place. It is mounted directly to the wiring harness that is routed underneath the intake manifold. It looks like one end is supposed to connect to the (what looks like the idle air control) on the far back port on the intake manifold on the drivers side right under the inter cooler. The vacuum line is about four inches long, and I will try to attatch a picture within the next day or so. If anyone with a wrx could look for me or pm me with a little info. I would apperciate any help in order to clarify my stupidity. Thanks

 

Bump for the sweet arrows in the pics!!!

 

I'll take a look when I get home, didn't drive it today.

 

Nothing goes in that "hole" in the back of the intake manifold. I'm not sure which vacuum line your talking about. There is one that comes up from underneath to the BOV.

You can use my car for reference if you'd like. I'm in VB...just pm me (again)

But I know I'm not the only WRX owner here !!!!


Whats up fellas !?!?!? Help a brother out...

 

It isn't connected to anything. If it's the one I'm thinking about at least... one end is connected to a black plastic thing, then it runs under the driver side intake manifold, turns 90 degrees down and just sits there.

 

Well, rexer called it and I confirmed it on Twelvz car last night. This damn vacuum line does not connect to anything. Maybe that is why I dont remember removing it. Oh well, chock it up to stupidity. Thanks for all the help guys.