need help asap with swap im trying to remove my 7mgte and prepare for swap

 

What do you wanna know?

 

trying to get help wth removing the engine

 

so u want people to come over and help you or u need to know what to do...its not that hard really

 

i want some one that knows what their doing to come help me bec i've never took out a 7m engine before

 

well i dont see how it would be any differnt than any other engine...
disconnect all electronics/harness
drain all fluids (oil, coolant, and maybe tranny depending on where u disconnect the drive shaft, if u take it off the diff u dont have to drain the tranny...if u take it off the tranny then it'd be best to drain it first so it doesnt pour out onto the ground)
disconnect drive shaft
take off shifter
unbolt motor and tranny mounts
pull

 

do you have a light blue/silver MkIII?

 

nether its grey

 

That engine can be pulled in a few hours, but you have to be careful about the injector harness, because it is a pain to get out without damaging it, if you aren't careful. Also, the radiator support is very easily damaged when pulling the motor out because there is little clearance. Other than that, it's no big deal.

What are you swapping in?

 

in kempsville area?