So, I took my jimmy into the shop a few days ago to replace the transmission lines and now that's turned out to cost $300. On top of that shitty bill, my mechanic told me that my rear bumper would not pass inspection because of the lift. I assumed it would pass inspection when I SPECIFICALLY ASKED THE OWNER if it would and he said yes. But no, that's not even the worst news for me today. The worst thing that I came to find out was that there is no such thing as a suspension lift for my mother fucking truck. What source did this come from? That's right, pungo. Well, dipshits, I wouldn't have got a body lift and asked about 35" swampers if I wasn't planning on getting a suspension lift. The only reason I even got this truck was to customize it and $500 later I come to a dead end. So, with that being said, fuck pungo off-road and fuck gmc.

I'm looking to buy a new truck now and I won't even consider it unless it's already lifted.

 

http://www.truckperformance.com/prod...inch+Lift+Kit/

http://www.stylinconcepts.com/parts....CategoryID/200

 

**nothing is imposible**

 

don't you just have to use an s10 lift kit for it? Same basic stuff on it



as far as your bumper not passing inspection.......thats BS because I don't even have one on my truck and its passed 3 years in a row now. My old roommate bought a car that had been hit in the rear and we tore off the bumper and it had bumper supports sticking out and still passed with flying colors. If it won't pass due to something like that just take it somewhere else

 

damn, that sucks ass but there is a lift for mine and the frame shouldn't be much of a difference maybe we can check into something of a newer model and it should be about the same I wil look around but damn that sucks and I could have done the transmission lines, what did you even need them on there for?

 

I'm really confused because I knew there were suspension lift kits for my jimmy online but pungo is saying no. They know a lot more sources for parts than I do, I just don't understand why they said it's impossible. As for my inspection, my dad won't take it to any other mechanic because he's a dick. The only "solution" to the bumper would be to bring the gap back down and open it even farther, which would look fucking stupid. As of right now, When the jimmy comes to mind, two words accompany it: fuck that.

 

The lines were rusted and I doubt you could have done them. As of right now, I'm looking for a lifted truck other than a POS jimmy.

 

A lift kit for an s-10 of the same year should work also, same suspension up front and in the rear, flip the axle.

 

anything can be lifted.

 

I use to have one and there is a kit for it, contact Pro Trucks.