FS: 88 turbo II project about 85% complete
#1
FS: 88 turbo II project about 85% complete
so i bought this car a few months ago with hopes to finish it and get it on the road but i ended up getting too far in over my head, i dont have the money for it, some rust but its nothing a sander cant buff off.. most of the work left is electrical work (wiring boost gauge, wiring efan) which i have no skill with and it needs some form of ecu/standalone/engine management system which i also lack knowledge in, i had an rtek 1.8 in her but i sold it cause i found i needed 4 sets of large injectors to run it and i didnt want to buy 2 pairs, and she might need some new tires and she'll be good to go
-rebuilt streetported 13bt was told these were added in the rebuild when i purchased the car from someone else; "rebuit with whole kit but added solid corner apex seals, teflon encapsuled water seals and 2mm apex seals. with new oil pump inside." the only thing thats been confirmed by me is the street port.. emissions blocked off, no ac or power steering(but i do have a power steering assembly with the car)
-Hks intake
-hks ssqv bov(not installed/welded on)
-autometer boost gauge(not installed)
-rx7 specific pillar gauge pod (not installed)
-Blue Recaro reclinable seats
-efan installed (but not wired comes with adjustable thermostat wiring kit & instructions)
-Ignition coils Two trailing and two leading
-Short shifter
-Racing Beat exhaust
-Catco high flow cat
-Racing beat downpipe
-kyb 6 way adjustables gas struts
-Tein lowering springs 1 inch drop
-Jspec s5 turbo almost no shaftplay
-brand new Stage two carbon kevlar racing clutch
-rebuilt front brake calipers
-turbo xs manual boost controller
-tre performance 255 lph fuel pump
-ARC top mount intercooler
-new starter
-new alternator
-new master slave cylinder,clutch cylinder,brake cylinder
-2 python 1000cc injectors
-2 rebuilt 550c injectors by rc engineering
-new fuel pressure regulator
-new water pump
-s5 tail lights
2300 OBO will consider trade for 5spd stock t2 or 5spd n/a with low miles or rebuild
pics below:
(no front mount installed this an old photo)
engine pics soon i gotta put it back together
-rebuilt streetported 13bt was told these were added in the rebuild when i purchased the car from someone else; "rebuit with whole kit but added solid corner apex seals, teflon encapsuled water seals and 2mm apex seals. with new oil pump inside." the only thing thats been confirmed by me is the street port.. emissions blocked off, no ac or power steering(but i do have a power steering assembly with the car)
-Hks intake
-hks ssqv bov(not installed/welded on)
-autometer boost gauge(not installed)
-rx7 specific pillar gauge pod (not installed)
-Blue Recaro reclinable seats
-efan installed (but not wired comes with adjustable thermostat wiring kit & instructions)
-Ignition coils Two trailing and two leading
-Short shifter
-Racing Beat exhaust
-Catco high flow cat
-Racing beat downpipe
-kyb 6 way adjustables gas struts
-Tein lowering springs 1 inch drop
-Jspec s5 turbo almost no shaftplay
-brand new Stage two carbon kevlar racing clutch
-rebuilt front brake calipers
-turbo xs manual boost controller
-tre performance 255 lph fuel pump
-ARC top mount intercooler
-new starter
-new alternator
-new master slave cylinder,clutch cylinder,brake cylinder
-2 python 1000cc injectors
-2 rebuilt 550c injectors by rc engineering
-new fuel pressure regulator
-new water pump
-s5 tail lights
2300 OBO will consider trade for 5spd stock t2 or 5spd n/a with low miles or rebuild
pics below:
(no front mount installed this an old photo)
engine pics soon i gotta put it back together
Thread
Thread Starter
Forum
Replies
Last Post
spnamnt
Parts ARCHIVE
42
08-23-2007 08:36 PM