Some Subi trash, Nitrous, Meth, BeeR,
09-21-2010, 07:14 PM
#1
Registered Member
Thread Starter
Join Date: Sep 2010
Location: Rockville
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
STi Top Mount, Bee R rev limiter, ARC, Nitrous, Meth,
Hey everyone, I got a few things I need to get rid of. Don't want to, but times are rough and they just got worse. Prices are up, but are negotiable so shoot me some offers. Also I'm in the Rockville/NOVA area, and local pickup is prefered but I'm willing to drive a reasonable distance. Thanks! 
STi TMIC - $200
-Comes with Y pipe and silicone coupler for the throttle body. The coupler for the hot side can be sourced from a local shop if absolutely necessary.
Stock exhaust pieces from a MY2004 WRX STi - $ Make an offer
-Everything is available
Stock STi *rear sway bar - $15
-Brand new endlinks
MY2002-2007 Muffler Delete axleback straight pipe - $15
-*recommend using extended hanger bushings to prevent bumper burn
BeeR Rev limiter/ launch control - $250
-This item builds boost at a pre-set rpm using ignition cut as opposed to fuel cut. I''m not here to start an argument over which is safer ignition cut vs. fuel cut, if you know what the Bee R is and you want it I have it. If you don't then do the research and then come back and buy it so I can pay for my iguana's breast implants. Thnx
link to hoonage:
http://www.youtube.com/watch?v=hlDvlBLPHwI&feature=related
AEM water, meth/ alchy kit - $250
-Comes with everything you need minus the low level warning light, but you can just run to radio shack and use a cheap l.e.d. for that. Mounting brackets for an EVO IX MR
ARC Panel Filter Air box - $400
-Pretty much brand new, was only used for seven hundred or so miles. Minus MAF adapter.
Nitrous Express 10lb. kit - $250
-Includes 10lb. bottle, two solenoids one for purge, one for spray. Lines, and mounts. You'll need jets, and to figure out wiring specific for your aplication.
Autometer Z series mechanical boost gauge - $20
-Good to 35 PSI *does not read vaccum! (who would buy a boost gauge that doesn't read vaccum? I don't know found it in my aunts medicine cabinet)
That's it for now. If I find anything else I'll post it up, and if you have offers, or questions lmk. Thanks everyone
Joe
STi TMIC - $200
-Comes with Y pipe and silicone coupler for the throttle body. The coupler for the hot side can be sourced from a local shop if absolutely necessary.
Stock exhaust pieces from a MY2004 WRX STi - $ Make an offer
-Everything is available
Stock STi *rear sway bar - $15
-Brand new endlinks
MY2002-2007 Muffler Delete axleback straight pipe - $15
-*recommend using extended hanger bushings to prevent bumper burn
BeeR Rev limiter/ launch control - $250
-This item builds boost at a pre-set rpm using ignition cut as opposed to fuel cut. I''m not here to start an argument over which is safer ignition cut vs. fuel cut, if you know what the Bee R is and you want it I have it. If you don't then do the research and then come back and buy it so I can pay for my iguana's breast implants. Thnx
link to hoonage:http://www.youtube.com/watch?v=hlDvlBLPHwI&feature=related
AEM water, meth/ alchy kit - $250
-Comes with everything you need minus the low level warning light, but you can just run to radio shack and use a cheap l.e.d. for that. Mounting brackets for an EVO IX MR
ARC Panel Filter Air box - $400
-Pretty much brand new, was only used for seven hundred or so miles. Minus MAF adapter.
Nitrous Express 10lb. kit - $250
-Includes 10lb. bottle, two solenoids one for purge, one for spray. Lines, and mounts. You'll need jets, and to figure out wiring specific for your aplication.
Autometer Z series mechanical boost gauge - $20
-Good to 35 PSI *does not read vaccum! (who would buy a boost gauge that doesn't read vaccum? I don't know found it in my aunts medicine cabinet)
That's it for now. If I find anything else I'll post it up, and if you have offers, or questions lmk. Thanks everyone
Joe
Last edited by aspen5; 09-22-2010 at 06:52 PM. Reason: ttits
09-21-2010, 10:17 PM
#2
Registered Member :)
Join Date: Jul 2007
Location: Richmond
Posts: 1,427
Likes: 0
Received 0 Likes
on
0 Posts
Bump for new egg roll making machine
09-22-2010, 06:37 PM
#4
Registered Member
Thread Starter
Join Date: Sep 2010
Location: Rockville
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Re: Some Subi trash, Nitrous, Meth, BeeR,
Arnold says bump it up
http://www.youtube.com/watch?v=pN253RLDdM8
Thread
Thread Starter
Forum
Replies
Last Post