ls vtec swap fully built darton sleeved,,
#1
Registered User
Thread Starter
Join Date: Nov 2005
Posts: 3,196
Likes: 0
Received 0 Likes
on
0 Posts
ls vtec swap fully built darton sleeved,,
Looking mostly for a trade: honda more luxary car for my family. just throw offers
Thanks
block:::
reason for selling is because i want to go all motor and a different swap.
trades k series full swap can be stock or with bolt ons.k24/a2 has to come with kpro unless its a k20a2 full swap with stock ecu with bolt on header mounts harness..or a k20r no mounts but with ecu/12.5 compression vtec swaps sleeved
setup for turbo
new head gasket
85 mm darton sleeved block..miles about 4k
9.1 aries pistons
eagle rods
itr oil pump
22t water pump
gsr girdle
arp studed
balenced and knife edged ls crank assem..
golden eagle ls vtec kit and sandwhich
p72 oil pan with turbo return line bung
block was built by rpr francisco
head::
pr3-4
stamp says 8/9
mild port job
3 angle valve job
skunk2 valvetrain minus cams
gsr cams stock gears
b16 intake manifold/throttle body
1000cc injectors
vtec engine harness
all sensors
tranny
ls with stg 4 competion clutch might swap for gsr tranny
shift linkege
little grind in third
b series axles
avid mounts
stock valve cover in black
obd1 dizzy new plugs
new valve cover kit
honda oil filter w/ drain plug washer
can come with hondata s200 boost
i/c piping w/greddy type s bov/xs power 24x12x3 intercooler
apexi turbo timer
Thanks
block:::
reason for selling is because i want to go all motor and a different swap.
trades k series full swap can be stock or with bolt ons.k24/a2 has to come with kpro unless its a k20a2 full swap with stock ecu with bolt on header mounts harness..or a k20r no mounts but with ecu/12.5 compression vtec swaps sleeved
setup for turbo
new head gasket
85 mm darton sleeved block..miles about 4k
9.1 aries pistons
eagle rods
itr oil pump
22t water pump
gsr girdle
arp studed
balenced and knife edged ls crank assem..
golden eagle ls vtec kit and sandwhich
p72 oil pan with turbo return line bung
block was built by rpr francisco
head::
pr3-4
stamp says 8/9
mild port job
3 angle valve job
skunk2 valvetrain minus cams
gsr cams stock gears
b16 intake manifold/throttle body
1000cc injectors
vtec engine harness
all sensors
tranny
ls with stg 4 competion clutch might swap for gsr tranny
shift linkege
little grind in third
b series axles
avid mounts
stock valve cover in black
obd1 dizzy new plugs
new valve cover kit
honda oil filter w/ drain plug washer
can come with hondata s200 boost
i/c piping w/greddy type s bov/xs power 24x12x3 intercooler
apexi turbo timer
Last edited by jdmontheway; 01-14-2010 at 07:21 AM.
Thread
Thread Starter
Forum
Replies
Last Post
gsrSII
Parts ARCHIVE
4
12-02-2008 06:49 AM
sh!ttyLS
Parts ARCHIVE
0
10-03-2008 08:25 PM