fully built b20 short block 85 mm
#1
fully built b20 short block 85 mm
I have a fully built b20 short block
Machinest sleeved punches out to 85 mm
Import builders super Dooper 13.8. :1 lightweight pistons eagle h beam rods arp head studs arp rod bolts golden eagle block guard also comes with the block motor is assembled comes with cometic head gasket that has only been on too check clearances never been through a heat cycle . Motor has not been ran yet . 1000$ obo please text or call 757 7778702 for additional info
Machinest sleeved punches out to 85 mm
Import builders super Dooper 13.8. :1 lightweight pistons eagle h beam rods arp head studs arp rod bolts golden eagle block guard also comes with the block motor is assembled comes with cometic head gasket that has only been on too check clearances never been through a heat cycle . Motor has not been ran yet . 1000$ obo please text or call 757 7778702 for additional info
Last edited by OH DATS ME; 05-07-2012 at 10:13 AM.
#4
Re: fully built b20 short block 85 mm
No problem!it is probably gonna be a machinest sleeve cause most after market sleeves sit too high to get a block gaurd in them!which for all.motor should be just fine
#6
Re: fully built b20 short block 85 mm
Not necessrily stock sleeves tbey could very well be a machinest sleeves which is more then capable of what this thing would make on motor!and yes ur right assuming it does have the aftermarket rods and those are not just some of the ctr knock off pistons in a 85mm fashion the the yes its a great deal
Thread
Thread Starter
Forum
Replies
Last Post
91CivicHB18A1
Engine / Exhaust / Drivetrain
20
05-03-2010 06:44 AM
Hammer Down
Engine / Exhaust / Drivetrain
12
01-06-2010 07:20 AM
jessetoedtman
Engine / Exhaust / Drivetrain
1
12-13-2009 11:24 AM