cheap place to get IC pipes bent and cut
Racetracks
Joined: Nov 2002
Posts: 15,668
Likes: 0
From: How long is a piece of string?
Re: cheap place to get IC pipes bent and cut
Buy prebent 45/90/J/U sections and piece them together (weld usually). Locally finding someone with a mandrel bender is going to be hard and very expensive.
Thread Starter
Oh Boy.
Joined: Aug 2006
Posts: 198
Likes: 0
Re: cheap place to get IC pipes bent and cut
well i bought an ebay pipe kit thats what i was saying, if i hacksaw em im afraid the edges will be rough and cut through my rubber connector pieces :\ but then i could always sand em down i guess
Thread Starter
Oh Boy.
Joined: Aug 2006
Posts: 198
Likes: 0
Racetracks
Joined: Nov 2002
Posts: 15,668
Likes: 0
From: How long is a piece of string?
Re: cheap place to get IC pipes bent and cut
Yes, you're going to want to debur those. Really though, you should find someone with a bead roller if you're going ot make any cuts. The bead is pretty important in keeping the rubber/silicone couplers from popping off under boost.
Thread Starter
Oh Boy.
Joined: Aug 2006
Posts: 198
Likes: 0
Re: cheap place to get IC pipes bent and cut
oh yeah, i forgot about that...thats why i was trying to get a shop to do it, cause im gonna be running at like 10 psi constant so that might be a good investment haha
Racetracks
Joined: Nov 2002
Posts: 15,668
Likes: 0
From: How long is a piece of string?
Re: cheap place to get IC pipes bent and cut
10 PSI is pretty low, but it's still good insurance for later. You'll be turning up the boost sometime, trust me. It's just too easy to add power..
