wondering because my girlfriend needs her keyless entry pad programmed so that she can use it for her car. have looked everywhere online and it says that a dealer has to program it for it to work. thanks in advance.!

 

bump

 

Have you tried this:

1. Get in the truck with the doors closed.
2. Hold down the unlock button on the door.
3. Turn the key from on to off 3 times without cranking the motor or until the horn sounds and the locks cycle.
4. After the locks cycle then release the unlock button.
5. Hold the lock AND unlock button down on the remote until the lock cycle, this should not take longer than 30-45 seconds.
6. Once all remotes are programmed turn the key on and the programming mode will end.

 

thanks for the input but it didnt work. thanks again though

 

ttt

 

Have you tried this:

1. Get in the truck with the doors closed.
2. Cycle the igintion to the 2nd spot then turn it off and it the unlock/lock button, and cycle the ignition again continuing to hit the remote button.Do this 3 times.
3. Door locks should lock/unlock showing you that the remote is programmed. Hit the unlock/lock to check and make sure.
4. If locks cycle, the remote is programmed.


this is what i did while working at acura to program remotes. Dont know how much of a difference there will be b/t gm and a honda.

 

This Is A Completely Different Manufacturer. I Work For Honda And Had To Reprogram The TPMS Sensors In A Tahoe After Replacing Four Tires. It Was A Nightmare. Damn GM Cars Cant Be Simple Enough.

 

the remote cannot be programmed by the consumer for my girls car. it must be programmed by a locksmith or the dealership

 

Then go to the dealership and get it programed..

If you cant do it, then it has to bee hooked up to the WDS (Or whatever GM calls their scanner).. No other way around it..

 

i know it has to be done by the dealership but not trying to pay an arm and a leg to get it done. was trying to see if anyone could do it if i brought it there for cheap