Looking for enine builder around roanoke
#2
EDM|Mugen|MK3 CRX
Join Date: Mar 2008
Location: Midwest and Virginia
Posts: 2,989
Likes: 0
Received 0 Likes
on
0 Posts
Re: Looking for enine builder around roanoke
Are you shaving the head to increase compression or to get the head flat? Take it to a machine shop let them do w3rk then do the rings and headgasket yourself. you can pull pistons and hone everything without pulling the motor.
#3
Re: Looking for enine builder around roanoke
i leave for the navy end of this month and dont have time to do it thats why hav to tak it to a shop and headgasket is leaking internally and externally thats why head needs to be shaved
#4
SAY IT WITCHA CHEST!
Join Date: Mar 2007
Location: Outer Space
Posts: 3,949
Likes: 0
Received 0 Likes
on
0 Posts
Re: Looking for enine builder around roanoke
well, unless your car overheated and warped the head when your head gasket blew, you shouldn't need to shave the head.
#5
WWW.TEAMDOHC.ORG
Join Date: Jan 2006
Location: TEAM DOHC, USA
Posts: 895
Likes: 0
Received 0 Likes
on
0 Posts
Re: Looking for enine builder around roanoke
Located in Lynchburg and can do the work. I have a machine shop that I use on a consistant basis and they give me good prices.
#6
Re: Looking for enine builder around roanoke
im really not sure if the head is warped i bought the motor from a junkyard with 11k i had a guy that works at honda help me put a new head gasket and arp head studs on, got it running and noticed antifreeze was leaking out of the head and it is some in the oil
#7
Registered member
Join Date: May 2006
Location: Roanoke
Posts: 3,781
Likes: 0
Received 0 Likes
on
0 Posts
Re: Looking for enine builder around roanoke
Sounds like possibly the Honda guy didn't do the head install correctly.Did ya'll follow the ARP torque steps and values?They're different from OEM.Did you measure head/deck warpage while they were apart?Also,why did you put a new head gasket on an 11k mile engine?
#9
Re: Looking for enine builder around roanoke
I think he torqued them the same as oem using the 3 90 degree steps because he was using a haynes manual for reference, replaced head gasket since took the head off since motor had been sitting since first of 04 and head wasnt checked
#10
Registered member
Join Date: May 2006
Location: Roanoke
Posts: 3,781
Likes: 0
Received 0 Likes
on
0 Posts
Re: Looking for enine builder around roanoke
Chris
Thread
Thread Starter
Forum
Replies
Last Post
manning
Western VA
5
08-19-2008 03:34 AM