Like the title says I am looking for a 92-95 ex/si harness and a p28 ecu for my d16z6 swap that I have sitting in my garage for my dx coupe. I think I will also need a speed sensor for the tranny because the one on mine is busted. Not sure if the one on my d15 tranny will work. If anyone knows let me know. Thanks

 

where are you located? i have the wiring harness

 

pm sent

 

D15 non vtec wiring harness will work. You will have to run a vtec wire yourself tho. Seen it done works fine. Just make sure to hide the wire for a clean look.

 

I have a speed sensor PM me.

 

i have the harness u need

 

location? pm me i have a p28

 

Thanks for looking guys and thanks for the advice civicman. Project is on hold until I finish rebuilding my brother in laws 4.0 SOHC explorer. My engine stand and hoist are being used for that right now. That motor is a piece of crap. Whoever designed it was a moron. We thought it blew a head gasket but when I pulled the heads off there was no sign of a leak. But while I had the heads off I noticed that the timing chain guides were busted on the front and back. The leak ended up coming from the front engine cover. So that meant the engine had to be pulled. I have the whole engine apart besides the crank and cams. I am putting in a new oil pump, timing chains, gaskets and gave the engine a good cleaning. But to avoid all of this trouble all you need to do is never buy a ford explorer. Anyways I am done venting. Probably gonna go to Atlantic City when I am done with this engine to relax for a weekend. Then I will get back to my project. Thanks again guys.