1ns0mniac

like title says i have a 38mm tial wastegate on a drag equal length manifold, and its sitting high that it hits the hood the whole time. there is now a big dent and alot of paint chipping and rust forming on the hood. i have a 92 civic hatch. how can i stop it from hitting the hood, before it makes a hole. thanks.

themacuser.org

take off your hood or get an engine lowering kit.

99blackcivicsi

why would you get a engine lowering kit???

Put some washers (and new bolts) on the bolts that hold the hood should raise it up at enough of an angle to clear it fine.

MKNTRAXX

What kinda engine mounts do you use.. need some stiffer ones.
Or make some kind of engine torque brace

Boostin10s

it has absolutely nothing to do w/ mounts or any of that other stuff they mentioned, you need a 90 degree elbow of your manifild. contact Myles at RevHard (www.revhard.com) and he'll hook ya up, good luck man
~STAY IN IT, BOOST BIG, RACE HARD !

1ns0mniac

thanks guys. millenium is going to bend my manifold so that the wastegate will point to the side instead of straight up. that'll fix it about right. thanks again.

99blackcivicsi

it has absolutely nothing to do w/ mounts or any of that other stuff they mentioned




so ur telling me that moving the hood up wont work?? i know it works and it is cheap only costs like 2 dollars man.

notsogoodfeline

It would sit funny?

Maybe a new manifold would look prettier..haha

1ns0mniac

its no good 99blackcivicsi. the wastegate is protruding up pretty high that a few washers and a good angle wouldnt fix it. otherwise i would have done it. thanks for the thought though.