Overboost?
06-18-2004, 12:55 PM
#1
<3's Photography
Thread Starter
Join Date: Apr 2004
Location: Fairfax, VA
Posts: 1,154
Likes: 0
Received 0 Likes
on
0 Posts
Overboost?
I just got my boost gauge installed b/c im about to turn up the boost. I went for a drive and the Greddy Electrical gauge reads:
.5-.6 bar in 1st
.5-.6 bar in 2nd
Spike to .7 then back to .6 bar in 3rd.
My question is: Why am I making too much boost. Im at stock boost with no boost controller or anything.
.5-.6 bar in 1st
.5-.6 bar in 2nd
Spike to .7 then back to .6 bar in 3rd.
My question is: Why am I making too much boost. Im at stock boost with no boost controller or anything.
06-18-2004, 01:05 PM
#2
Administrator
Join Date: Nov 2002
Location: أنا لست إرهابيا
Posts: 10,636
Likes: 0
Received 0 Likes
on
0 Posts
Re: Overboost?
What does your exhaust system consist of?
__________________
Got a 1995-1996 240SX? Want a new front bumper?
Check this out. Posting on drag first to try and avoid shipping it.
Got a 1995-1996 240SX? Want a new front bumper?
Check this out. Posting on drag first to try and avoid shipping it.
06-18-2004, 01:31 PM
#3
the baddest assed
Join Date: Dec 2003
Location: Richmond VA
Posts: 1,122
Likes: 0
Received 0 Likes
on
0 Posts
Re: Overboost?
sounds like not enough boost to me.. how much were you expecting?
if it didnt rattle the pistons dont worry about it
whats the deal with bar and not psi? i like bigger numbers
if it didnt rattle the pistons dont worry about it
whats the deal with bar and not psi? i like bigger numbers
06-19-2004, 05:57 AM
#8
<3's Photography
Thread Starter
Join Date: Apr 2004
Location: Fairfax, VA
Posts: 1,154
Likes: 0
Received 0 Likes
on
0 Posts
Re: Overboost?
alright, i just did a 4th gear pull and it held steady at .75 bar really close to .8 bar. I dont want this much boost. My fuel pump hasnt come it yet. What should i look over?
06-21-2004, 10:43 PM
#9
❒Good ❒ Better ✔Best
Join Date: Nov 2002
Location: Fredericksburg
Posts: 4,598
Likes: 0
Received 0 Likes
on
0 Posts
Re: Overboost?
the greddy doesn't read in Bar, i am almost positive it reads in kgf/cm2. 0.6 would be ~8.5 lbs, .7 is ~9.95 lbs. dont worry if it's just a spike, where it settles is what you should be concerned with. 1st and 2nd gear readings are worthless also, 3rd and 4th are what you want to pay attention to