the old N1 crank pulley question?
#1
FS/Dope Status troll
Thread Starter
Join Date: Sep 2005
Posts: 719
Likes: 0
Received 0 Likes
on
0 Posts
the old N1 crank pulley question?
still cant get a straight or educated answer from anyone about ctr pulleys. anyone out there actually have one on there car or had a bad experience with one? i understand it has no rubber in it so it will not absorb "shock" from the crank but it is a factory part that is used on the CTR and i wouldnt think honda would engineer a part that would destroy an engine. anyone have any info?
#2
Re: the old N1 crank pulley question?
the only problem i had with my ctr pulley, is not being able to run AC, and power steering. "duh"
i have one on my LS, and haven't had a bit of shit to deal with.
i have one on my LS, and haven't had a bit of shit to deal with.
#4
Huntin Dropa ForLife
Join Date: Dec 2002
Location: Virginia Beach, VA
Posts: 8,735
Likes: 0
Received 0 Likes
on
0 Posts
Re: the old N1 crank pulley question?
i run a non-dampening crank pulley and have seen no bearing issues. However, on my 95mm crank, i'll be adding a damper.
#6
FS/Dope Status troll
Thread Starter
Join Date: Sep 2005
Posts: 719
Likes: 0
Received 0 Likes
on
0 Posts
#9
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: the old N1 crank pulley question?
If everything is balanced as least as good as stock, there should be no reason for oil pump failure. There is some other reason if people are destroying pumps..
#10
FS/Dope Status troll
Thread Starter
Join Date: Sep 2005
Posts: 719
Likes: 0
Received 0 Likes
on
0 Posts
Re: the old N1 crank pulley question?
Thank You! debunk all this ignorance! i would agree if everything else is str8 it should cause problems. plus there aint shit to the pulley: less mass and weight. Hmmm....think i should get a brand new one balanced for shits and giggles?