Need more cold crank amps to turn a motor over, have 2 batteries, how to connect?
Thread Starter
superuser
Joined: May 2003
Posts: 20,828
Likes: 0
From: Glen Allen VA
Need more cold crank amps to turn a motor over, have 2 batteries, how to connect?
Need to use the power of two 750 cca batteries to turn over an engine, one isn't enough. How would I wire it up to get the amps but not any added voltage? Having a brain-free moment and can't think of how to do it...
EMF Member #12
Joined: Feb 2005
Posts: 1,184
Likes: 0
From: VA
Re: Need more cold crank amps to turn a motor over, have 2 batteries, how to connect?
You are describing a parallel wiring situation. Wire the positives together and then the negatives together. I'll try and find a picture to demonstrate. But this will keep the voltage the same but add the amps.
Thread Starter
superuser
Joined: May 2003
Posts: 20,828
Likes: 0
From: Glen Allen VA
Re: Need more cold crank amps to turn a motor over, have 2 batteries, how to connect?
Thanks. 
Wasn't sure if it would increase voltage, if it doesn't then that's the setup I need and can use the F350's two batteries to handle this. Will try that this evening to get the monster turned over. Been sitting for awhile.
Wasn't sure if it would increase voltage, if it doesn't then that's the setup I need and can use the F350's two batteries to handle this. Will try that this evening to get the monster turned over. Been sitting for awhile.
Thread
Thread Starter
Forum
Replies
Last Post
