need help with intake etc etc
#1
Banned
Thread Starter
Join Date: Sep 2006
Location: Va beach
Posts: 830
Likes: 0
Received 0 Likes
on
0 Posts
need help with intake etc etc
ok so i just got a pm6 and put it in my car after doing my mpfi swap not to long ago,and im only throwing a iac which isnt too bad just when its cold
but ok with the pm6 if i have wide open throttle,like fully,the car will bog down and feel like it has no throttle response at all,but if i take a slowly and floor it like3/4 it drives fine with no problems at all
any ideas what the problem could be
i have a pm5 map sensor which is my guess,but also maybe the ignition timing is off,or a possible vacum leak,but im clueless
like i said im only throwing code 14 no other ones at all
it didnt do this on a pr4 but it was dumping way to much gas so this is my only option,even if i get ran over trying to get on the interstate
but ok with the pm6 if i have wide open throttle,like fully,the car will bog down and feel like it has no throttle response at all,but if i take a slowly and floor it like3/4 it drives fine with no problems at all
any ideas what the problem could be
i have a pm5 map sensor which is my guess,but also maybe the ignition timing is off,or a possible vacum leak,but im clueless
like i said im only throwing code 14 no other ones at all
it didnt do this on a pr4 but it was dumping way to much gas so this is my only option,even if i get ran over trying to get on the interstate
#7
Sumospeed #O.G.
Join Date: Apr 2003
Location: Va Beach
Posts: 2,514
Likes: 0
Received 0 Likes
on
0 Posts
Re: need help with intake etc etc
Check your wiring and make sure nothing came loose. My car sis the same thing you are describing and it ended up being the wiring came loose at the ecu. Could also be your tps. try another throttle body.
#8
Banned
Thread Starter
Join Date: Sep 2006
Location: Va beach
Posts: 830
Likes: 0
Received 0 Likes
on
0 Posts
Re: need help with intake etc etc
nothing was loose,just when i did my mpfi harness i cut off the electric aircontrol valve,instead of the purge control valve(dual point intake manifold)
so i just had to go back in and we wire it
so its fixed
so i just had to go back in and we wire it
so its fixed
Thread
Thread Starter
Forum
Replies
Last Post
John M
Want to Buy / Trade ARCHIVE
9
07-08-2008 04:19 PM
jujub1
Want to Buy / Trade ARCHIVE
12
01-25-2008 04:21 AM